2 votes

Pass cable guide tube hole

I wanted through a tube installation guide, but there is no way. Reached a point does not pass Guide. And over, what most I mosque, is that if I go to the other side of the tube, I can you put a little more, but very similar. In a way, 10 meters I can stick a 9 and a half yde another 20 cm less or something well. What can I do?

2voto

Anon User Points 0
That tends to happen because both the few cm from the beginning of the entry "To" there is a closed curve and the same thing happens to output "B" so that, even if you use one or the other as the entrance area of the guide cable, always at the end of the tour, which is when the least force exerts the guide, you find yourself with a closed curve and with difficulties to get the guide to advancement, about all also because you can match the tube is a little loose just in those curves, or even have any stone or remains of plaster swarming the tube. First cover a little bit of a mouth of the tube (with a newspaper threaded p. e.) and on the other applies a vacuum to try to remove possible residues or, without obscuring the mouth applied an air compressor to blow the tube. Second, try a guide with a spiral like this: [https://www.amazon.es/gp/aw/d/B01NAZJE4Y/ref=ox\_sc\_saved\_image\_1?ie=UTF8&psc=1&smid=A1FAJ20CCTVKR6](https://www.amazon.es/gp/aw/d/B01NAZJE4Y/ref=ox_sc_saved_image_1?ie=UTF8&psc=1&smid=A1FAJ20CCTVKR6) Using a lubricating gel such as this: [https://www.amazon.es/gp/aw/d/B001RNA6MG/ref=aw\_wl\_ov\_dp\_2\_8?colid=302LFS4SXRNLO&coliid=IR5CAHX6E6SF8](https://www.amazon.es/gp/aw/d/B001RNA6MG/ref=aw_wl_ov_dp_2_8?colid=302LFS4SXRNLO&coliid=IR5CAHX6E6SF8) Both of these things you will find, surely, at a better price in stores, distribution of electrical material. Also, try to put a guide on one side and, if you are stuck, without removing it, puts another guide for the other end to coincide in point of critical and a to facilitate the movement of the other in that last stretch. You'll need to be two people at the same time so that the thing can work and, above all, that having a lot of luck.

1voto

Anon User Points 0
Have I believe that I have not understood at all. The tube is empty, without cables. What use is a cable no cable directly. And what seems strange to me is that if I put it by the entrance to stays at 60 cm from exit b, and if I get it by exit b, stays at 1 m from the entrance, so no matches to the same end of tubing, is caught in dis different sites...

1voto

Anon User Points 0
It is likely that the pipe at some point this crushed by that does not let you guide

1voto

Anon User Points 0
Use some gel bushing or Vaseline. If you already have wires inside release them tie guide them and remove them, then passes everything that you need with those who already had.

0voto

Anon User Points 0
It is also possible that you have a very closed curve. If you have a stuck cable you can use it to power the contacts or cables.

TheXpert.space

TheXpertSpace is an online community of people who give and receive advice.
You can check other people responses or create a new question if it's not already solved

Powered by:

X